Friday, December 23, 2016

Boat Update III

Winter is slowing the work on the boat a bit down. Epoxy doesn't set in low temperatures and the shed I'm using doesn't have heating. I did use a small electric heater but it's difficult to get the temperature up. As you can see I have all the main work done, side decks, fore deck and coaming. It's all a matter of fairing and filling up holes now. After that, paint and varnish :) In the second photo you can still see what the old boat used to be (the blue parts) and the new part set in between. Also, the outboard fitted to check it's low enough in the water. Can't wait to try her out.


Monday, October 10, 2016

DIY Traffic Light For Kid's Bedroom

My cousin turned 8 years old and for his birthday he wanted something that could prevent his mom or anyone from entering his room without permission. Specifically, he wanted a stoplight. Naturally this appealed to my diy brain and I started working on it. I had no plan, I just wanted to make a wooden box with a red and green light, a batteryholder and a switch. Unfortunately I didn't have the right switch available so I had to mount separate switches for the red and green light. My cousin didn't bother with such technical details :)








Tuesday, October 4, 2016

Boat Update

The weather is getting colder here, autumn is upon is and thus limited time to work with epoxy. Managed to get a lot of work done, the outer hull is sealed and ready for paint, the interior needs one more coat of epoxy. After all the itchy sanding I finally had a chance to start working on the cockpit coaming, the edge around the cockpit and I like how it looks :)


Saturday, September 17, 2016

Boat Work Update

So I've cut my boat in half, added a new middle section, and now I'm working on making it one piece again. It's taking much more time than I expected, as usual. I made frames to support the new construction and recently started to add supports for the deck that will cover the front of the boat. The main part of this covered area will be used as flotation in case the boat get's swamped. Between the open cockpit and the flotation area is room for storage and you can see the opening for an access hatch I made.

The cockpit will be surrounded by a coaming, or a ledge, lean against when you sit. And I've made a new transom, a thicker one that can support the outboard engine. Still a lot to do, sanding, epoxy and fiberglass on the outside of the hull, paint, etc etc. And I will be making my own navigation lights. I hope to make some video's about those in the next couple of weeks. I'm making all of this up as I go, so tension is starting to build, I have no idea how this new boat will behave. For instance, it is quite narrow at 110 cm. It will be interesting to see how the length of the boat, 360 cm (12 feet) will behave with an outboard on top of the transom. Keeping my fingers crossed until launch day :)




Saturday, June 11, 2016

Bandai Star Wars Box Sized Star Destroyer Video Build

Bandai Star Destroyer Build by Bar's Projects
















I'm currently making video's of this tiny (110 mm) Star Wars scale model build with lighting, check it out here: Bar's Projects Youtube Channel

Tuesday, April 12, 2016

Is Cutting a Boat in Half a Good Idea?

I built a small sailboat some years ago but it wasn't very usefeul. Cause it was too small for me. So I was thinking of building a new boat, from scratch. But then I thought, wait a minute, why not just make the boat I have a little bit bigger? There's all sorts of issues with that idea but nevertheless I'm going to try it against better judgment :) Here's the start of that project, after I had cut the boat in half, using stitch and glue technique to extend the boat by 4 feet. You will see in this blog in the coming months wether this was a good idea or not.


Friday, April 8, 2016